BRAYER BR4205, Инструкция по эксплуатации

Страница: 9 / 48

9 EN
the flexible hose (7) for obstruction. Remove the
obstruction, after that you can resume cleaning.
USING THE VACUUM CLEANER
• The dust bin (11) is equipped with the cyclonic filter
(24) which eliminates garbage and dust from the air,
and the foam filter (25) and the inlet filter (26) retain
the finest dust particles.
Note: provide that the HEPA filter (19) is always clean,
because the overall performance of the vacuum cleaner
depends on it.
Attention! Before switching on and using the vacuum
cleaner make sure that the cyclonic filter (24), the filters
(25, 26), the dust bin (11) and the outlet HEPA filter are
installed properly.
• Take the power plug and unwind the power cord to
the required length, connect the power plug to the
mains socket.
• The yellow mark on the power cord indicates the
maximum cord length. Do not pull out the power cord
further than the red mark.
• Press the on/off button (13) to switch the vacuum
cleaner on.
• While cleaning you can control the suction power
using the manual suction power control (6) on the
flexible hose handle (5) and by turning the suction
power control (17).
• After you finish cleaning, switch the vacuum cleaner
off by pressing the on/off button (13) and unplug it.
• To wind the power cord, press the button (18); keep a
hold of the winding cord with your hand.
• If you have to make a break during the cleaning,
switch the vacuum cleaner off by pressing the button
(13) and install the brush (1) to the brush storage
(21).
ATTENTION! Before changing the attachments or
cleaning the dust bin (11), switch the vacuum cleaner off
by pressing the on/off button (13) and unplug it.
CLEANING AND MAINTENANCE
Cleaning the dust bin (11)
• It is recommended to remove garbage and dust from
the dust bin (11) after every room cleaning.
• Switch the vacuum cleaner off by pressing the on/off
button (13) and unplug it.
• Holding the handle (15), press the lock (14) and
remove the dust bin (11) (pic. 4).
• Place the dust bin (11) over a garbage bin.
• Press the clamp (22) and open the lower lid (23)
(pic. 5).
• Remove accumulated dust and garbage from dust
bin (11).
• Close the lid (23).