BRAYER BR4203, Инструкция по эксплуатации

Страница: 9 / 44

9 EN
USING THE VACUUM CLEANER
The dust bin (11) is equipped with the cyclonic filter (24)
which eliminates garbage and dust from the air, and the
inlet filter (25) and the foam filter (26) retain the finest dust
particles.
Note: provide that the filter (25) and the foam filter (26)
are always clean, because the overall performance of the
vacuum cleaner depends on it.
Attention!
Before switching on and using the vacuum cleaner make
sure that the cyclonic filter (24), the filters (25, 26), the
dust bin (11) and the outlet HEPA filter (19) are installed
properly.
• Take the power plug and unwind the power cord to the
required length, connect the power plug to the mains
socket.
• The yellow mark on the power cord indicates the
maximum cord length. Do not pull out the power cord
further than the red mark.
• Press the on/off button (16) to switch the vacuum
cleaner on.
• While cleaning you can control the suction power using
the manual suction power control (6) on the flexible
hose handle (5) or by turning the suction power control
knob (17).
• After you finish cleaning, switch the vacuum cleaner off
by pressing the on/off button (16) and unplug it.
• To wind the power cord, press the button (14); keep a
hold of the winding cord with your hand.
• If you have to make a break during the cleaning, switch
the vacuum cleaner off by pressing the button (16) and
install the brush (1) to the brush storage (15).
ATTENTION!
Before changing the attachments or cleaning the dust
bin (11), switch the vacuum cleaner off by pressing the
on/off button (16) and unplug it.
CLEANING AND MAINTENANCE
Cleaning the dust bin (11)
• It is recommended to remove garbage and dust from the
dust bin (11) after every room cleaning.
• Switch the vacuum cleaner off by pressing the on/off
button (16) and unplug it.
• Hold the dust bin handle, press the clamp (13) and
remove the dust bin (11) (pic. 1).
• Place the dust bin (11) over a garbage bin.
• Press the clamp (21) and open the bottom lid (20) (pic.
2).
• Remove accumulated dust and garbage from dust bin
(11).
• Close the lid (25).
• Install the dust bin (11) back to its place and make sure
that the dust bin (11) is fixed properly.