Page 10
Do not adjust
the inner roll
stop linkage
rod unless
extra usable
platform length
is needed.
See Photo F.
Linkage rod adjustment affects angle
of inner roll stop (vertical position).
CAUTION
Improper inner roll
stop linkage rod
adjustment may
result in lift damage.
If the angle of the inner roll stop (when in the
vertical position) restricts the usable platform
length for the wheelchair passenger, adjust-
ment of the linkage rod will change the angle.
Adjust the inner roll stop as detailed in the
previous procedures. Then, adjust the link-
age rod as detailed (only if necessary). If the
linkage rod is over adjusted (too long or too
short), it will exceed the travel of the slider
block resulting in damage to the cam follower
bearing, the cam and/or other components.
F
Floor Level and Inboard Locator Adjustments
Usable Platform Length
Inner Roll Stop
Linkage Rod
G
H
1-1/2" Minimum
Clearance
Torque Tube
Linkage Rod Adjustment
1. Position the lift platform below stow
level using the manual hand pump
(turn valve counterclockwise). Do
not operate the lift with the electric
pump during adjustment procedures.
2. Loosen the jam nuts at each end of
the linkage rod. Adjust rod length as
needed. Minimize adjustment. Pro-
vide a minimum of 1-1/2" clearance
between inner roll stop and torque
tube (inner roll stop must clear cylin-
der mount). See Photo H.
3.
Carefully check the inner roll stop
angle and operation using the hand
pump. Ensure the linkage rod has
not been over adjusted resulting in
pressure on components (damage
will result).
4. Tighten the linkage rod jam nuts.
