35
-
First press the white button (fig.2/9) on the left hand side of the TURNY. The top
and bottom flaps will open. Remember to open wide and flex the book before you
place it in the TURNY. Place the books front and back covers under the two large
clamps to hold the book tight. The top of the book must be placed parallel to one
of the blue horizontal lines displayed at the top of the front board. The middle of
the book must be on the blue vertical line in the centre of the front board. Now
push the lower bar (fig.2/3) with the bottom flap upwards until the book rests on
it. The easiest mounting method is to place the book a little higher than required,
move the lower bar to the correct position and lower the book onto the bar.
Open the book to the required page. Flatten the book and press the white button
(fig.2/9) again. The top and bottom flaps will close. The adhesive roll should
now be just to the left of the edge of the book. If not, adjust the turning arm with
the adhesive roll. Open the screw on top of the unit (fig.2/6) and adjust the length
of the arm, moving the arm back and forth slightly in order to center it. Be sure the
adhesive roll (fig.2/13) is parallel to the board and the book. Then tighten the screw.
Do not use pliers or undue force. After tightening, move the arm back to the starting
position, with the adhesive roll alongside the left cover of the book. If the pin of the
arm is incorrectly positioned, the adhesive roll will stick to the front board.
See chapter „Problems and Solutions“.
-
The outer pages of thicker books can sometimes greatly slope off diagonally,
causing the adhesive roll to grasp the pages wrongly. In order to counteract this,
it is possible to place a smaller, thinner book, or something similar, under the thin
side of the book you want to read.
