Brandt TI214, Руководство по эксплуатации и установке

Страница: 11 / 48

11
You have doubts about whether your hob is working correctly ....
...... this does not
necessarily mean there is a breakdown. Nevertheless, check the following points
Minor troubleshooting
WHAT SHOULD
YOU DO?
POSSIBLE
CAUSES
IF YOU REALIZE THAT
Call the After Sales Service
Check the connection and make sure it
complies with requirements.
This is normal.
The electronic circuit is working badly.
Your hob is connected incorrectly
Your hob is connected incorrectly
The electronics are cooling down
See containers.
The saucepan you use is unsuitable for
induction cooking or its diameter is
under 12 cm. (10 cm on the 160 mm
zone).
Inspect the fuses and the cut-out
switch.
The apparatus is not under power.
There is a power or connection problem.
The hob does not work , another message comes
on
When you switch on, the fuse blows
When you switch on, only one side of the hob
works
The fan keeps going for a few minutes after the hob
has been switched off
After having turned on a heating zone, the keyboard
displays continue to flash.
Clean the hob or remove the object in
question and start cooking again.
Something has overflowed and or an
object is touching the control panel.
The hob stops working during operation,
a ,
or F7 come on.
The hob does not work. Displays on the key-
board do not come on
A series of little (or F7 ) appears
Electronic circuits have overheated.
See "Fitting your hob".
The electronics are under power as for
all other electronic apparatus (TV,
transformers, etc.).
The top of the hob is always warm (even when it is
switched off).
NOTHING: see chapter Remarks on
connections
The hob is working normally When you switch on, the display lights up
This is normal.
If the slightest break or crack appears in the ceramic glass surface, disconnect the
unit immediately and contact your After Sales Service.
This comes from vibrations made by
energy going from the hob to the pan.
The pans make a noise during cooking
Under high power this phenomenon is
normal with certain types of pans. There
is no danger for the hob.
Use each heating zone for ½ hour
with a pan full of water.
A new apparatus
The hob gives off a smell when first used for
cooking
99629733_ML_A.qxd 17/02/04 16:43 Page 11