Brandt BPG6308 Series, Руководство по установке и использованию

Страница: 8 / 24

8
2 / INSTALLING YOUR APPLIANCE
•CHOICE OF LOCATION
Your appliance should be fl ush mounted in
the surface of a support cabinet that is a
minimum of 3 cm thick, made of a material
that resists heat or that is covered with
such a material.
So as not to inhibit the movement of
cooking utensils, there should not be to
any obstacle within 30 cm of the hob to the
right or left or back.
If a horizontal divider wall is positioned
under the hob, it should be placed between
10 cm and 15 cm away from the top of the
work surface. Never store aerosol cans or
pressurised containers in any compartment
that may exist under the hob (see chapter
“Safety instructions”).
•FITTING
Before installation of your appliance and to
ensure leaktightness between the drawer
unit and the work surface, make sure that
you glue the seal provided in the plastic bag
(Fig. 02).
— Remove the pan supports, the burner
covers and burner heads; noting their
positions.
— Turn the hob over and carefully place it
on top of the opening in the cabinet so as
not to damage the knobs and spark plugs.
— Glue the foam seal, supplied with the
appliance, to the outside edge of the
49 cm
3 cm mini
10 cm mini
10 cm mini
27 cm
7,5 cm mini
70 cm mini
Fig. 01
Fig. 02
Seal
APPLIANCE
Width Depth Thickness
Standard
cabinet cut-out
27 cm 49 cm
depending
on cabinet
Total dimension
above the work
surface
30 cm 51,5 cm 5 cm
Total dimension
below the work
surface
26,3 cm 48 cm
5,1 cm
frame . This seal ensures leaktightness
between the glass and the work surface.
— Place your hob in the opening of the
support unit, carefully centering it in the
cut-out.
— Reposition the pan supports, burner
covers and burner heads.
— Connect the hob’s power cable to your
kitchen’s electricity supply (see section
“Electricity connection”).
— Connect your appliance to the gas supply
(see section “Gas connection”).
Housing