Brandt 1912720, Инструкции по эксплуатации и монтажу

Страница: 33 / 77

32
The doors normally open to the left (hinges on the right); if you wish to open the door to the right,
you can modify the direction in which it opens by following the instructions below. To ensure
correct installation, please scrupulously follow the directions and the sequence of operations
below:
1. Gently tilt the appliance backwards (with the doors
facing upwards).
2. Remove the plinth by pulling the lugs A on the lower
part towards you and swivelling the plinth upwards
to disengage it (R1). Remove cover B from its hous-
ing on the left and insert it in the housing on the right
(R2).
3. Remove the bottom hinge pin and release it from its
housing C; retrieve the plastic distance piece placed
between the door and the hinge on the pin; unscrew
the bottom hinge D and screw the pin into the
left-hand hole in the hinge (R3).
4. Remove the freezer's door (R3).
5. Unscrew the middle hinge E, taking care not to lose
the plastic distance pieces inserted on the pin (R3).
6. Remove the covers G on top of the refrigerator door
(R4).
7. Free the refrigerator's door from the top hinge (R4).
8. Remove the screw and the covers F on the left-hand
side of the appliance and insert them in the holes on
the right-hand side (R3) .
9. Remove the covers H from the control panel (R5).
10. Unscrew and remove the top right-hand hinge I
(R5).
11. The upper left-hand hinge L is placed inside the
plinth (R6). Remove it and inset it into the housing on
the left on the control panel M . Fasten it with the
two screws (R7).
Reversing the direction the doors open
EN
drawing R1
A
A
drawing R2
B
drawing R5
drawing R4
G
I
H
H
drawing R3
D
E
F
C