BrainBee multigas 8500, Руководство по обслуживанию, Страница: 12 / 78

ENGLISH 12 / 78 CAP. 5 - INSTALLATION
MULTIGAS 8500
Until the activation code is entered into the equipment, it will always be requested.
5.1.7 EC declaration of conformity and Use and maintenance manual
Deliver the EC Declaration of conformity document attached to the equipment to the client, it will
have to be carefully kept by the end customer.
Deliver and illustrate the use and maintenance manual attached to the equipment which will have to
be carefully kept by the end customer and made available to the operators.
5.1.8 First tank filling (including weight and pressure check)
To proceed with first filling of the equipment inner tank, execute the following actions in sequence by
following the display guided procedure and the illustrations on the summary sheet provided with the
equipment:
ALTITUDE COMPENSATION
The altitude compensation procedure shall be executed in case of installation in a location
above 500m a.s.l. (this is aimed at improving the station performance, which can be
affected by atmospheric pressure that changes in relation to altitude). Every time the station
is moved to an altitude other than the one at which the sensor was calibrated or the initial
check was carried out, a new calibration at the altitude of destination is required.
Enter the menu:
Service, using the password “XHIGH”
Altitude – enable the function [when pressure is reset or calibrated, the station will
require setting the altitude range (with 500m intervals) where the station is
located].