Braillo 650 SW2.1, Руководство пользователя

Страница: 62 / 137

BRAILLO
l
B 650 SW2.1
62
4.12 Unrecoverable errors:
When there is an unrecoverable error, the display will show what has
happened e. g. “General failure, Beam wheel failure”. When this kind
of errors occurs, the printer must be reset or switched off and then
switched back on again.
The job currently being printed has to be sent once more from the
computer. The different unrecoverable errors are:
- Magnet failure
A defect magnet has been detected during printing. The display will
say “General failure, Magnet rack failure” and the magnet symbol will
appear in the upper right hand corner of the display. The printer will
stop. Check the log for the details.
(Main Menu - Warning - Service/diagnostic - Warning - View Log)
When trying to print after a defect magnet is found and replaced, the
display will still show the magnet symbol in the top right hand corner.
This is because you have to reset the magnet failure.
To reset the magnet failure, you have to select the menu choice Clear
magnet failure . See ‘Clear magnet failure:’ on page 55 for more
info.
(Main Menu - Warning - Service/diagnostic - Clear magnet failure)
If the display shows ”General failure, Magnet rack failure” without
the magnet symbol in the top right corner, it means that there has
been detected error(s) in e.g. the data transmission between the main
board and the magnet racks, or it could be a broken fuse for the pow -
er to one magnet rack.
- Illegal ESC sequence
The printer has received an ESC sequence that it doesn’t recognize, it
is placed in wrong location on the page, or contains invalid parame -
ters.
Press OK to continue.