Braillo 650 SW2.1, Руководство пользователя

Страница: 38 / 137

BRAILLO
l
B 650 SW2.1
38
4. OPERATING THE PRINTER
The figure below is a schematic drawing on how the paper travels through the machine.
4.1 Adjust to paper width
All these adjustments are dependent on the paper roll width, so it can be wise to use a paper sample
to set the width.
It is recommended to start with the paper feeder unit nearest to the main belt (the right-hand one
when looking in the direction the paper travels), because this will also determine the top margin on
the sheet.
The adjustment should be done in this order:
1. Move the feeder unit nearest to the main belt to the desired position. (Note the top margin).
2. Adjust the other feeder unit so the distance between them is equal to the paper width.
3. Put the paper into the Printer, and align the guides on the input tray.
4. Adjust the width on the stacker, add a couple of millimeters on each side.
5. Adjust the end stop to fit with the sheet length.
See figures on the following pages.
Stacking
Cutting Printing
Feeding Unwinding