CONTENTS
WARNING!
Important Safety Information
FEATURES
SPECIFICATIONS
INSTALLATION
Replacing Existing Thermostat
Installing Your New Thermostat
TESTING YOUR NEW THERMOSTAT
PROGRAMMING
Default Thermostat Settings
Setting Current Time of Day and Day of Week
Setting Thermostat User Options
Setting Temperature Differentials
Setting Residual Cooling Fan Delay
Setting Extended Hold Time
Setting Filter Check Monitor
Setting Recirculating Fan Cycle
Setting Your Energy Saving Programs
Tips Before Starting
Programming Overview for 7 day Programming Mode
Entering Your 7 day Program
Programming Overview for weekday-weekend
(5-2 day) Programming Mode
Entering your weekday-weekend (5-2 day)
day Program
ADDITIONAL OPERATION FEATURES
Review Set Temperature
Temporary Program Override
Extended Hold (Vacation) Mode
Filter Check Monitor
Keypad Lockout
Adaptive Recovery Mode
Recirculating Fan Mode
High Temperature Safety Switch
Compressor Protection
Changing Fahrenheit (˚F) to Celsius (˚C)
Low Battery Detection and Replacement
LED Status Indicator
Resetting the Thermostat
TROUBLESHOOTING
WIRING DIAGRAMS
1
2
3
4
5
6
7
8
5.1
3.1
3.2
5.2
5.3
5.4
6.1
6.2
6.3
6.4
6.5
6.6
6.7
6.8
6.9
5.4
.1
5.4
.2
5.4
.3
5.4
.4
5.4
.5
• Always turn off power to the air conditioning or heating system prior to installing, removing,
cleaning or servicing thermostat.
• Read this manual thoroughly prior to installing, programming or operating this thermostat.
• This thermostat is designed for use with a 24 Volt AC low voltage multi-stage heat / cool system.
• Do not use this thermostat on systems with voltages higher than 30 Volts AC.
• This thermostat requires 24 Volt AC Power for normal operation and control of the heating or
cooling system.
• The thermostat also requires two (2) properly installed "AA" alkaline batteries to retain clock
settings in the event of loss of AC Power due to power outage or rolling blackouts.
• Wiring must conform to all building codes and ordinances as required by local and national code
authorities having jurisdiction.
• Do not short (or jumper) across terminals on the gas valve or at the heating or cooling system
control board to test the thermostat installation. This could damage the thermostat and void
the warranty.
• Do not select COOL mode of operation if the outside temperature is below 50˚ F (10˚ C). This
could possibly damage the controlled cooling system and may cause personal injury.
• This thermostat should only be used as described in this manual. Any other use is not
recommended and will void the warranty.
1
5.3
.1
5.3
.2
5.3
.3
5.3
.4
5.3
.5
6.10
6.11
6.12
6.13
