Brady Bradyprinter THT 300X-PLUS, Руководство пользователя, Страница: 41 / 180

Getting Started
Connect the Printer to a Power Source
Bradyprinter THT X-Plus II Series User Guide 13
Connect the Printer to a Power Source
To connect the printer to a power source, complete these steps:
1.
Turn the printer power switch (located on the rear of the printer) to the Off ( O
)
position.
2.
Plug the power cord into the mating connector on the rear of the printer.
3.
Plug the other end of the power cord into the power source.
Power Cord
Depending on how your printer was ordered, a power cord may or may not be
included. If one is not included or if the one included is not suitable for your
requirements, refer to the following guidelines.
Your power cord must meed these standards:
•
The overall length must be less than 9.8 ft (3.0 m).
•
It must be rated for at least 5 A, 250 V.
•
The chassis ground (earth) must be connected to ensure safety and reduce
electromagnetic interference.
The ground connection is handled by the third wire (earth) in the power cord as
shown in the following illustration.
Caution • For personnel and equipment safety, always use an approved
three-conductor power cord specific to the region or country intended for installation.
This cord must use an IEC 320 female connector and the appropriate region-specific
three-conductor grounded plug configuration.
1
AC power plug for your country
2 3-conductor HAR cable
3
IEC 320 connector
4 Neutral earth live in contact view
1 2 3 4