Brady Bradyprinter THT 300X-PLUS, Руководство пользователя, Страница: 149 / 180

Troubleshooting
Communications Problems
Bradyprinter THT X-Plus II Series User Guide 121
Communications Problems
This table identifies problems with communications, the possible causes, and the
recommended solutions.
Problem Possible Cause Recommended Solution
A label format was sent
to the printer but was
not recognized. The
DATA light does not
flash. The communication
parameters are incorrect. Check the printer driver or software
communications settings (if applicable).
If you are using serial communication,
check the serial port setting in the front
panel menu. See
Setting Serial
Communications on page 85 .
Make sure you are using the correct
communication cable. See
Data Cable
Requirements on page 16 for the
requirements.
Using the front panel controls, check the
protocol setting. It should be set to
NONE
.
See Setting Protocol on page 86 .
If a driver is used, check the driver
communication settings for your
connection.
A label format was sent
to the printer. Several
labels print, then the
printer skips,
misplaces, misses, or
distorts the image on
the label. The host is set to EPP
parallel communications. Change the settings on the computer host
to standard parallel communications. See
Setting Parallel Communications
on page 85 .
The serial
communication settings
are incorrect. Ensure that the flow control settings
match.
Check the communication cable length.
See
Data Cable Requirements on page 16
for requirements.
Check the printer driver or software
communications settings (if applicable).