Brady Bradyprinter THT 300X-PLUS, Руководство пользователя, Страница: 104 / 180

76 Bradyprinter THT X-Plus II Series User Guide
Front Panel Controls
Front Panel LCD
Front Panel LCD
Use the LCD display on the front panel to adjust printer settings. In the following
table, parameters are shown in the order in which they are displayed when you press
NEXT/SAVE after entering setup mode. Throughout this process, press NEXT/SAVE
to continue to the next parameter, or press PREVIOUS to return to the previous
parameter in the cycle.
LCD Description
PRINTER READY
This message displays after the Power-On Self Test (POST) is complete.
DARKNESS
Adjusting Print Darkness
Darkness settings depend on a variety of factors, including ribbon type, labels,
and the condition of the printhead. You may adjust the darkness for consistent
high-quality printing.
If printing is too light, or if there are voids in printed areas, you should
increase the darkness. If printing is too dark, or if there is spreading or
bleeding of printed areas, you should decrease the darkness. Darkness settings
also may be changed by the driver or software settings.
The FEED Self Test described in the
FEED Self Test on page 126 can also be
used to determine the best darkness setting. Because the darkness setting takes
effect immediately, you can see the results on labels that are currently printing.
Caution •
Set the darkness to the lowest setting that provides good print
quality. If the darkness is set too high, the ink may smear, or the ribbon may
burn through.
•
Press the right oval to increase darkness.
•
Press the left oval to decrease darkness.
Default: +4
Range: 0 to +30.0