Brady BP-IP300, Руководство пользователя

Страница: 57 / 75

Control Panel
50
Print Parameters
Press the menu key.
Select
Setup > Print param.
Parameter Meaning Default
Heat level
Heating value to compensate for different
thermal behavior of printheads. Changing
this value is necessary if the printing intensity
has changed after replacing the printhead.
To adapt the printing intensity when using
different media, print speeds or printing
contents, you should change the heat level in
the software. The settings from the
Print
param.
menu and the software are added
together.
The heat level setting also affects the test
printouts.
0
Print speed
Basic print speed setting.
You can specify the print speed for each print
job via software.
The print speed setting also affects the test
printouts. 100 mm/s
Transfer
print
On
for thermal transfer printing: Sensor for
monitoring the transfer ribbon is activated.
Off
for thermal direct printing: Sensor for
monitoring the transfer ribbon is not
activated.
You can overwrite the setting for each print
job via software.
On
Warn level
ribbon
Warning sent via the Ethernet interface by
way of an SNMP message or e-mail sent
when the remaining diameter of the ribbon
supply roll undershoots the set value
1.2–3 inches (32–74 mm). Off