7
Bradley Corporation • 215-1372 Rev. F; EN 03-045
Terreon® Tri-Fount™ Wall-Hung Washfountain with Battery-Operated Infrared Control
Installation Instructions
MF2939/BIR
9-17-2003
Installation Instructions continued . . .
Step 4: Assemble and install bowl
1. Install two 3/8" wall anchors (supplied by installer). These will be used to mount the bowl to the
wall.
WARNING: Do not attempt to install the bowl by yourself. To prevent serious injury,
install the bowl with the assistance of another person and always use
appropriate lifting procedures.
2. With the help of an an assistant, carefully lift the bowl on the pedestal frame using appropriate
lifting procedures. Ensure bowl remains 3 - 4 inches from the wall.
WARNING: Do not leave the bowl on the pedestal unsupported, as it may fall and
cause personal injury or damage to property.
3. Install the 2 wall anchor brackets to the back of the bowl using the 3/8-16 x 2" hex head bolts,
13/32" I.D. plain washers, anchor plates, lockwashers and hex nuts provided as shown in Figure 4.
4. Remove valve boxes from the bowl assembly.
5. Secure the bowl’s wall brackets to the wall anchors with two 3/8" diameter bolts and washers
(supplied by installer).
6. Fasten the front underside of the bowl to the upper bracket on the pedestal frame with the two
1/4-20 x 1/2" round head screws and 5/16" I.D. washers supplied.
7. Install the drain spud in the bowl using plumber’s putty (see Figure 5) (discard rubber washer).
8. From beneath bowl, thread the washer and locknut onto the drain spud and tighten the locknut
against the bowl.
9. Install strainer in the bowl drain using the two #10-24 x 1/2" oval Phillips head screws supplied.
Figure 4
Figure 5
Spud
Washer
#10-24 x 1/2"
Screw for
Strainer
Drain
Spud
Dome
Strainer
Discard this
washer; it is not
used on
washfountains
Washfountain
Bowl
Spud
Locknut
Drain Assembly
Back View of Washfountain Bowl
