Installation
SS-3N/BIR3/STD, SS-3N/BIR3/WH
Bradley
• 215-1496 Rev. J; ECN 17-08-026
9/7/2018
7
SCUFF PANEL
STANDARD HEIGHT
FRAME ONLY
SCUFF BASE FRAME
STANDARD HEIGHT
FRAME ONLY
Anchoring the frame to a wall that is not flat may cause the
frame to bend, making it difficult to reinstall the access panels.
If necessary, use shims to compensate for wall distortion.
2
Mount the Frame
A
Using a T20 torx key, remove the
fasteners securing the access panel to
the main frame, and remove the panel.
Scuff Panel
Standard Height
Frame Only
Scuff Base Frame
Standard Height
Frame Only
B
Once you have positioned the frame
such that it is level and flat against the
wall or shimmed, mount the frame to
the wall at six places using 3/8" bolts
and 1" min. O.D. washers.
3
Install the Bowl
The sprayhead body has slotted holes for adjusting the fit-up with
the bowl and wall. For clarity, the scuff base frame and drain are
not shown. Turn the tailpiece down to its proper position before
installing the bowl.
A
Attach the bowl to the frame using
the ¼-20 x ½" pan-head screws and
washers. Do not tighten screws.
B
Secure the
bowl to the wall
anchors with
two 3/8" bolts
and washers. Do
not overtighten.
C
Tighten the pan-head
screws. Do not overtighten.
