Installation
SS-3N/BIR3/STD, SS-3N/BIR3/WH
Bradley
• 215-1496 Rev. J; ECN 17-08-026
9/7/2018
15
Fill Soap Dispenser
The soap valve will dispense vegetable/coconut oil liquid soaps, synthetic detergents, viscous lotion soaps, and
antiseptic solutions. A 10-15% con cen tra tion is rec om mend ed for veg e ta ble or co co nut oil liquid soaps. Before
filling, rinse out each soap tank with hot water to remove packing dust. Shake water out thor ough ly and allow to
dry. Do not over fill!
Filler
Hole
#10 Screw
Leaf Spring will engage
when soap tank is
pushed into place.
Soap Valve Repair Kit (S65-258) includes:
• Nut
• Spring
• Washer
• Plunger
Soap Blank
Coal (133-143B)
Clean Soap Dispenser
NOTICE! Do not use abrasive cleansers to clean the soap tank. Abrasive cleaners can damage the surface.
Regular cleaning of the soap dispenser is recommended to ensure optimum performance and maximum service life. Cleaning the
soap dispenser monthly to remove soap residue, dirt, and other accumulations should become a regular part of your washroom
cleaning routine and general maintenance program.
Clean exterior: Use warm water and soap to clean the exterior of the soap dispenser. Dry with a soft cloth.
Clean interior: Inspect the interior of the tank for residue or coagulation of soap. If necessary, clean the tank according to the
following procedure:
1. Pour out any remaining soap in the tank.
2. Full the tank half-full of hot water and shake the tank to dislodge the soap residue.
3. Empty the water from the container and repeat steps 1 and 2 until the soap container is clean.
If rinsing alone does not remove the soap residue, place a small chain (24 inches long) into the tank with hot water and shake the
container until the chain dislodges the residue. Then remove the chain and rinse out the tank.
Clean internal components: Pump hot water through the soap dispenser until a clean flow of water comes out of the valve.
To change soap, pour out all of the soap from the dispenser and rinse with hot water several times until all residue is removed.
Pump the valve until clean water appears. Rinse the dispenser with ethyl alcohol; air dry before refilling.
Soap tank kit S65-291B (coal) includes:
• Coal Tank w/ Valve (S11-220B
• Leaf Spring (S39-350)
• Screw (160-385)
