background image

“THERMOSTATIC”

MODELS COVERED:

EFT-5500-4-S-10         240V
EFT-6500-4-S-10         240V
EFT-7500-4-S-10         240V 
EFT-9500-4-S-10         240V
EFT-8300-2-S-10         208V
EFT-6000-5-S-10         277V
EFT-8000-5-S-10         277V
EFT-9000-5-S-10         277V
EFT-10000-5-S-10       277V

ELECTRIC INSTANTANEOUS WATER 

HEATER

INSTALLATION GUIDE AND OWNERS MANUAL

READ THIS MANUAL CAREFULLY BEFORE ATTEMPTING TO INSTALL OR OPERATE 
THIS WATER HEATING UNIT.  IF YOU DO NOT FOLLOW THE SAFETY RULES, THE 
UNIT WILL NOT OPERATE PROPERLY AND COULD CAUSE DEATH, SERIOUS 
BODILY INJURY AND OR PROPERTY DAMAGE.

READ ALSO THE ENCLOSED WARRANTY CARD.  WARRANTY OF THIS WATER 
HEATING UNIT WILL DEPEND ON PROPER INSTALLATION AND OPERATION.  THE 
WARRANTY SHALL BE VOID IF THE DESIGN HAS BEEN ALTERED IN ANY WAY 
WHATSOEVER.  THE MANUFACTURER OF THIS UNIT WILL NOT BE LIABLE FOR 
ANY DAMAGES BECAUSE OF FAILURE TO COMPLY WITH THE INSTALLATION AND 
OPERATING OUTLINED ON THE FOLLOWING PAGES. 

THE INSTALLATION MUST CONFIRM WITH THE INSTRUCTIONS IN THIS MANUAL; 
ELECTRIC COMPANY RULES; AND LOCAL CODES, OR IN THE ABSENCE OF LOCAL 
CODES, WITH THE LATEST EDITION OF THE NATIONAL ELECTRICAL CODE.  A 
COPY OF THE NATIONAL ELECTRICAL CODE IS AVAILABLE FROM 
UNDERWRITERS LABORATORIES, 333 PFINGSTEN ROAD, NORTHBROOK, IL, 
60062

.

IF ASSISTANCE IS REQUIRED OR ANY QUESTIONS ARISE RELATING TO THE 
INSTALLATION OR THE PERFORMANCE OF THIS UNIT,  CONTACT TECHNICAL 
SERVICE DEPARTMENT TOLL FREE AT 1-800-334-3393.         

HAVE THE INFORMATION LISTED BELOW BEFORE CALLING:

MODEL NO.

SERIAL NO.

INSTALL DATE

.

Содержание Kwickshot EFT-5500-4-S-10








Отзывы: