BR3010
LED 10W CCT All in One Floodlight
BR3020
LED 20W CCT All in One Floodlight
BR3030
LED 30W CCT All in One Floodlight
BR3050
LED 50W CCT All in One Floodlight
BR3001
Plug in PIR
CCT All in One Floodlight
Features
Dimensions
•
Colour temperature selectable
–
3000K/4000K/5000K
•
Plug and play IP65 PIR connection
–
PIR sold separately
•
Integrated IP65 connector to terminate the cable directly into
•
Toughened glass diffuser and aluminium housing
•
Ideal and energy efficient LED technology replacement for
traditional flood lights
Width (W)
Depth (D)
Height (H)
10W
109mm
60mm
156.5mm
20W
126mm
60mm
166mm
30W
164mm
60mm
197mm
50W
189mm
60mm
217mm
Safety Instructions
1.
These instructions should be read carefully and retained after installation for future reference and maintenance.
2.
Ensure that the mains power is switched off before carrying out installation or maintenance.
3.
Check that the total load on the circuit including this luminaire does not exceed the rating of the circuit cable, fuse or circuit breaker
4.
It is recommended that luminaires are installed and fitted by a qualified electrician ensuring the installation complies with the current
edition of IET wiring regulations - BS 7671. This luminaire is electrical class 1 construction and must be earthed.
5.
Ensure all electrical connections are secure and that there are no loose strands.
Environmental Instructions
This product may contain substances that can be hazardous to the environment if not disposed of properly. Electrical and electronic
equipment should never be disposed of with general household waste but must be separated for its correct treatment and recovery.
Where possible recycle your packaging.
Installation Instructions
–
Standard Flood Light
SUGGESTED METHOD OF INSTALLATION
Read instructions and check you have all the tools and accessories
to complete the installation safely and in compliance with current
electrical standards.
1.
Switch off the electricity at the fuse box by removing the
relevant fuse or switching off the circuit breaker before
proceeding with the installation.
2.
On rear of the flood light, unscrew the connector cover to
reveal the wiring terminals. Terminate one end of a 3-core
cable into the connector terminals, ensuring the correct
polarity is observed and the unit is earthed. Replace the
connector cover back in place to sure the cable is secure,
and the IP rating of the connector is maintained.
3.
Use the mounting bracket as a template to mark hole
centres. Drill the fixing holes and fit suitable wall plugs.
Secure the metal bracket in place with screws.
4.
Using a suitable hex key, loosen the bracket bolts on side
of the floodlight to adjust the floodlight to desired angle
5.
Terminate the mains supply cable into the terminals in the
suitable junction box. The live conductor should be in-line
with the circuit breaker and any isolation switches
Standard Wiring
- Brown to live
- Blue to neutral
- Green / Yellow to earth
6.
Use the CCT changing rocker switch to select the desired
colour temperature. Switch on the power supply and
check the operation.
