© BQT Solutions (SEA) Pte Limited
Page 7
5.2.3 Fitting the lock into the housing
Once wired, the lock is slid into the housing and
secured in place with the supplied M5 machine
screws. Make sure that the wiring integrity is
maintained as the lock is screwed in place.
5.2.4 Fitting the strike plate housing to glass
For simple application to glass the YD30M housing
is supplied with self-adhesive tape. With the
backing removed the housing can be applied
directly to the glass. A flat stainless steel dress
plate is fitted on the opposite side of the glass to
give a clean finish. The protective coating on the
dress plate can be removed once it is in place.
5.2.5 Fitting the strike plate into the housing
The strike plate is placed into the housing and
secured in place with the supplied M5 machine
screws.
5.2.6 Checking the operation
With the lock and strike installed and wiring
complete the door is closed to check the alignment
and operation. The key area for alignment is the
bolt pin; the pin is designed to touch the leading
edge of the strike plate hole to pull the door in, but
it cannot be allowed to touch the sides of the hole
as this will limit its unlocking ability. If its rubs or
touches the side of the strike plate hole, either the
lock or strike plate needs to be re-positioned.