bpr Rotax 912 i Series, Руководство по обслуживанию, Страница: 73 / 458

Effectivity: 912 i Series
Edition 1/Rev. 0
d
053
36.
fm
MAINTENANCE MANUAL
BRP-Powertrain
24-30-00
Page 3
July 01/2012
SYSTEM DESCRIPTION
The ROTAX 912 i Series can optionally be
equipped with an external alternator. This is a
state-of-the-art, electromechanical three-phase
generator (compact generator) with small outer
dimensions. It has the task of supplying the elec-
tric consumers with energy and charging the
starter battery with the least possible fuel
consumption and low noise levels during opera-
tion of the aircraft.
DRIVE
Drive is provided by the engine by means of a V-
belt.
SAFETY INFORMATION
MAINTENANCE
As well as the maintenance and special checks,
see the relevant Maintenance Manual Line for
the respective 912 i Series engine type.
EXTERNAL ALTERNATOR - REMOVAL
Before the external generator is removed, the
work described below must be carried out to
identify any further faults in the external genera-
tor and rectify them as part of repair work.
- General visual inspection. See relevant Main-
tenance Manual Line for the 912 i Series
engine type.
- Carry out a generator inspection during an
engine test run. See relevant Maintenance
Manual Line for the 912 i Series engine type.
- Output voltage check. See "Documentation of
aircraft manufacturer"
m
WARNUNG
m
WARNING
Danger of damage to engine!
There is a risk of short circuits and cable fires
during work on the electric system.
All installation work on the electric system
should be carried out with the engine switched
off and the battery (negative terminal) dis-
connected.
Ignition, main and LANE selector switches must
be "OFF"!
m
WARNUNG
NOTICE
If these checks are omitted, it may be necessary
to dismantle the internal generator again to rec-
tify any faults after repair work.