bpr Rotax 912 i Series, Руководство по обслуживанию, Страница: 445 / 458

Effectivity: 912 i Series
Edition 1/Rev. 0
d
059
41.
fm
MAINTENANCE MANUAL
BRP-Powertrain
79-00-00
Page 23
July 01/2012
REMOVAL
REMOVAL OF THE OIL LINE
REMOVAL OF THE OIL LINE (STEEL LINE)
Fig. 29
INSPECTION
OIL LINE - INSPECTION
Preparation
- Clean all parts carefully. See also section 05-
00-00 Procedures
- General visual inspection. See relevant Main-
tenance Manual Line for the 912 i Series
engine type.
m
WARNUNG
NOTICE
The oil lines are not included in the delivery of
the engine and must be maintained according to
the aircraft manufacturer's instructions.
Step Procedure
1 Remove the oil lines and clamps accor-
ding to the instructions in the aircraft ma-
nufacturer's manual.
m
WARNUNG
NOTICE
The steel oil lines, which are included in the de-
livery, are only removed if they are damaged or
for cleaning.
Step Procedure
1 Remove the cable clamp for supporting
the line on the side of the gearbox.
2 Loosen the M10 banjo bolt and gasket
ring on the governor flange. See also sec-
tion 61-20-00 Governor.
3 Loosen the banjo bolt on the oil pump
housing and remove it along with the gas-
ket rings. See also section 61-20-00 Go-
vernor.
1. Oil line 2. Cable clamp
3. M10 banjo bolt