bpr Rotax 912 i Series, Руководство по обслуживанию, Страница: 443 / 458

Effectivity: 912 i Series
Edition 1/Rev. 0
d
059
41.
fm
MAINTENANCE MANUAL
BRP-Powertrain
79-00-00
Page 21
July 01/2012
Fig. 28
INSTALLATION
OIL TANK - INSTALLATION
Preparation
- Install the oil tank according to the aircraft
manufacturer's specifications.
FINISHING WORK
- Fill with fresh oil.
See relevant Maintenance Manual Line for
the 912 i Series.
- Bleed the oil system.
See relevant Maintenance Manual Line for
the 912 i Series.
- Carry out an engine test run and leakage
check.
REMOVAL
REMOVAL OF THE OIL COOLER
Preparation
- Switch the ignition key OFF
- Drain the oil
- Remove surrounding assemblies and detach
oil lines.
NOTE:
The assemblies and lines are only to be
removed if necessary and only as far as
is necessary!
m
WARNUNG
NOTICE
The oil cooler is not included in the delivery of
the engine. Maintenance must be carried out in
accordance with the aircraft manufacturer's in-
structions.
m
WARNUNG
m
WARNING
Danger of severe burns and scalds! Always
allow the engine to cool down to ambient tempe-
rature before starting any work.
ENVIRONMENT NOTE
Dispose of used oil according to local environ-
mental regulations.
m
WARNUNG
NOTICE
Use appropriate protective coverings to prevent
the ingress of debris particles into all dis-
connected lines and connections.
Step Procedure
1 Remove the oil lines and clamps accor-
ding to the instructions in the aircraft ma-
nufacturer's manual.
ENVIRONMENT NOTE
Ensure that no oil gets into the waste water sys-
tem or the ground – risk of contaminating drin-
king water!