bpr Rotax 912 i Series, Руководство по обслуживанию, Страница: 350 / 458

Effectivity: 912 i Series
Edition 1/Rev. 2
d0
667
4.
fm
MAINTENANCE MANUAL
BRP-Powertrain
76-10-00
Page 34
July 01/2014
INSTALLATION
- The regulator is installed and removed in the
same way. The following should be noted.
NOTE:
If the wire is broken or the connector
is defective, the damage can be re-
paired. The cable must be long
enough if the connector is cut off. Re-
pair with the tools described here
must comply with the aircraft stan-
dard of the respective country.
Fig. 40
Fig. 41
REGULATOR B - INSTALLATION
NOTE:
When using a heat transfer pad, no
additional application of a thermal
compound is required.
part no. from the Connector Set associated Tool
866420 DEUTSCH HDT- 48 - 00
866422
1. Regulator A 2. DEUTSCH connector
(black)
1. Regulator B 2. DEUTSCH connector
(grey)
m
WARNUNG
NOTICE
All hex nuts (self-locking) must be renewed after
each installation (e.g. replacement of a regula-
tor).
m
WARNUNG
NOTICE
The adhesive surface on the back of the rectifier
regulator must be cleaned before applying the
heat transfer pads. Remove the protective film
with caution, because rapid stripping can dam-
age the heat transfer pad.
Step Procedure
1 Clean the regulator plate: Remove residu-
es of the thermal paste or the heat trans-
fer pads.
2 Bonding the heat transfer pad to the recti-
fier regulator: Remove the protective film
from heat transfer pad and stick theheat
transfer pad with the adhesive surface
onto the rectifier regulator (avoid any folds
or bubbles). The positioning has to be
done as shown in
Fig. 42 .