Cleaning, maintenance and repair
19
Sprühboy 14 Airmix Edition 05.07
5.2.1
Cleaning the air and agent nozzle
- Separate the compressed air supply from the
external compressed air source. Refer to chapter
"Adjusting agent and spraying pressure", page 13
in this regard.
- Pull the bleed valve until the hissing noise stops.
Refer to chapter "Filling the stainless steel
pressure vessel", page 12 in this regard.
- Spray the spray gun until it is empty so that no
residual pressure is left.
- Unscrew the air nozzle (1) by hand and remove.
- Unscrew the agent nozzle (1) from the connection
piece (3) with the special wrench supplied (2) and
remove.
Only use the special wrench supplied to
unscrew and tighten the agent nozzle.
- Clean the air nozzle and the agent nozzle using
hot water.
- Blow out the agent nozzle with compressed air or
with the mouth against the direction of flow.
By holding the agent nozzle up to the
light, check whether there are still any
particles inside the agent nozzle.
- Screw the agent nozzle (1) back onto the
connection piece.
- Firmly retighten the agent nozzle with the special
wrench supplied.
- Screw the air nozzle back on and tighten by hand.
- Replace the spray gun in its mount.
1
2
1
3
