Boyens Backservice Jelly Mini Boy Digital Airmix, Инструкция по эксплуатации, Страница: 20 / 43

20
Putting into operation
Jelly Mini Boy - Digital Airmix Edition 12.08
4.9 Setting the spraying pressure
It is imperative that you comply with the
chapter "General requirements on the
compressed air source", page 12.
The spraying pressure may be set
between 0.5 bar and a maximum of 4
bar.
The consistency of the material to be
processed determines the necessary
spraying pressure. More viscous agents
require a higher spraying pressure.
Only a correctly set spraying pressure
will ensure a reasonable spray pattern.
Increase the spraying pressure, if you
want to enlarge the spray pattern.
Reduce the spraying pressure, if you
want to reduce the spray pattern.
- Spray out the agent by the spray gun.
- Simultaneously turn the adjusting screw (1) via
screwdriver until the agent will discharge from the
spray gun in the desired manner.
To adjust the spraying pressure, turn the
adjusting screw (1) into the desired
direction.
Increasing the spraying pressure -
turn the adjusting screw anti-
clockwise.
Reducing the spraying pressure -
turn the adjusting screw clockwise.