Pre Start Inspection and Operation
3.11
Cylinder Lock Installation
Make sure to install the cylinder lock before performing any service work underneath
the raised loader arm assembly.
1. Start the engine. (See Machine Start-up in this section for engine starting instructions).
2. Fully raise the loader arm.
3.
Shut off the engine.
4. Release the cylinder lock from its storage position (Item 1,
Figure 3–10
) by removing the
lock knob (Item 3,
Figure 3–10
) and pulling the safety lock pin (Item 2,
Figure 3–10
).
5. Place the cylinder lock (Item 5,
Figure 3–10
) onto the cylinder rod.
6. Fully reinsert the safety lock pin (Item 4,
Figure 3–10
), securing the cylinder lock in the
support position.
Make sure that the safety lock pin goes behind the loader arm cylinder rod.
7. Lower the loader arm assembly until it is supported by the cylinder lock.
Figure 3-10 Safety Lock Installation
Cylinder Lock Removal
1. Start the engine and raise the loader arm to its full height.
2.
Shut off the engine.
3. Pull the safety lock pin (Item 4,
Figure 3–10
) fully outwards.
4. Return the cylinder lock to the storage position (Item 1,
Figure 3–10
) on the loader arm.
5. Fully insert the safety lock pin (Item 2,
Figure 3–10
) and the lock knob (Item 3,
Figure
3–10
) to secure the cylinder lock in the storage position.
WARNING
NOTICE
1
2
3
4
5
