
13
IMPORTANT! -
We strongly recommend that you
check for gas leakage prior to operation of your
machine. We recommend that you close the cylinder
valve when the machine is not in use. BOSSWELD
authorised representatives or agents of BOSSWELD
will not be liable or responsible for the loss of any gas.
MIG SYNERGIC SETUP
Note:
Pictures may vary from your machine model
4. Connect MIG Torch to the
Euro Connection terminal
NOTE: Ensure connector
nut is tighten firmly
11 & 12. Fit gas regulator to bottle and
install gas hose to the inlet on the back
panel of welder. Turn on regulator and
set gas flow to between 10-15 L/min
depending on your welding environment
10. Select MIG Synergic mode
4. Connect polarity switching
cable to the terminal
5. Connect earth clamp
to the terminal
Roller Groove
V Groove - Mild Steel
U Groove - Aluminium
V-knurled - Gasless Wire
Drive roller
size (mm)
Plug the machine 10Amp input power lead
into the wall socket, ensuring that the power
switch on the machine is in the OFF position.
1
Open wire feed side panel and install GAS
wire into machine ensuring the drive roller is
matched to the wire size and type. Refer to
Machine Drive Roller Size Guide on page 41
Note: Wire to roll from under spool into the
wire guide inlet tube
2
Set up the wire feed unit as per section
“Set up Wire Feed Unit”. Ref page 40
3
DCEN - GASLESS
DCEP - GAS
SETTING MACHINE POLARITY
Install Euro connect MIG torch over the
protruding wire, line up and screw the Euro
connector nut up firmly. Ensure the polarity
switching cable is plug into positive output
connection socket for gas welding.
4
OFF