WASP
TM
Wireless Acceleration Sensor Puck Operations Manual
- 4 -
1.
Introduction
1.1.
WASP2 Sensor Inroduction
This Operations Manual provides basic information on how to operate the
WASP™Wireless Acceleration Sensor Puck (WASP2)
This manual covers the following topics:
Installation of WASP™
Assembling of WASP™
Placement of WASP™
Optional Thermal Calibration of WASP™
Troubleshooting
2.
Installation
2.1.
Included In The Package
Each sensor puck is shipped complete with the WASP2 Vibration and Temperature
Sensor Assembly, a WASP2 Battery Cap Assembly, a Gasket, and mounting screws to
secure the top cap.
The BossPac
WASP™ and WASP2 sensor pucks use an attached magnet base for
mounting to equipment. Optional mounting methods are available, (stud mount, pipe
clamp, epoxy).
2.2.
Assembling Of Wireless Sensor Pucks
2.1.1 Battery Installation
Each sensor puck is shipped with a WASP2 Battery Cap Assembly containing a battery
circuit board. The Battery Cap Assembly contains a non-removable long-lasting lithium
battery.
WARNING
– USE ONLY WITH REPLACEABLE BATTERY BOSSPAC EA00029X
WARNING
– EXPLOSION HAZARD. DO NOT REMOVE BATTERIES UNLESS AREA
IS KNOWN TO BE NON-HAZARDOUS.
AVERTISSEMENT
– RISQUE D’EXPLOSION. AFIN D’ÉVITER TOUT RISQUÉ
D’EXPLOSION, S’ASSURER QUE L’EMPLACEMENT EST DÉSIGNÉ NON
DANGEREUX AVANT CHANGER LA BATTERIE.
