BOSSCO 20810, Руководство по сборке

Страница: 7 / 7

made to size
Holden Colorado RG 12+ - Some Colorado’s have factory mounting holes. They are
hidden under roof trim and may have some body paint
covering it.
- 1x M8 bolt per triangle base bracket (separately packaged)
- There are 4 holes per side of the car. Our brackets use the 2
inner holes.
- If there are no holes, new holes will have to be drilled
Isuzu D-Max 12+ - Some D-Max’s have factory mounting holes. They are hidden
under roof trim and may have some body paint covering it.
- 1x M8 bolt per triangle base bracket (separately packaged)
- There are 4 holes per side of the car. Our brackets use the 2
inner holes.
- If there are no holes, new holes will have to be drilled
Volkswagen Amarok - Uses factory mounting holes inside ‘pop off’ section
- 1x M6 bolt & 1x 3-nut-plate per triangle base bracket
(separately packaged)
- 3-nut-plate is used a spacer to fill void in the roof so that the
base bracket can sit flush. Base bracket is not able to sit
inside the void by itself. The bolt does not thread into the 3-
nut-plate.
Toyota Hilux 2015+ - This car has a very narrow roof moulding. If you were to
remove the roof moulding and try to fit the triangle base
bracket in the gap, it would not fit.
- The solution is to make a hole in the roof moulding and sit
the triangle base bracket on top of the roof moulding so that
it is raised up and flush with the roof. This also looks a lot
neater and cleaner.
- A bit of clear 3M tape is recommended so that the edge of
the triangle base bracket is not scratching the paint