10
Using the EXP/CTL Jack
*
When an EV-5 or FS-5U is connected to the EXP/CTL jack, the
PH-3’s own pedal switch then only turns the effect on and off.
*
When disconnecting from the EXP/CTL jack, the RATE (tempo)
settings used up to that point are cleared, with the RATE knob
setting then becoming effective.
When Connecting the (Optional) Roland EV-5
The RATE settings can be adjusted with the EV-5.
You can change from the minimum RATE value set by the EV-5’s
Minimum Value to the value set with the PH-3’s RATE knob.
1.
Connect the EV-5 to the EXP/CTL jack, and
press the pedal completely forward. The
adjustment made with the RATE knob in this
condition determines the maximum RATE
value when controlled with the EV-5.
2.
Return (raise) the pedal completely back so
the heel is down. The adjustment made with
the RATE knob at this point determines the
minimum RATE value when controlled with
the EV-5.
When Connecting the (Optional) BOSS FS-5U
The tempo can be set with the FS-5U.
Concerning how to make the tempo settings, refer to steps 3
and 4 under ”Setting the Tempo with the PH-3’s Pedal Switch”
(p. 9). Simply substitute “FS-5U” where it says “PH-3’s pedal
switch.”
*
The PH-3’s pedal switch switches the effect on and off. When
the effect is on, the CHECK indicator flashes alternately in red
and green.
*
If you turn the RATE after setting the tempo with the FS-5U,
the RATE knob value is then adjusted.
*
You can also make the tempo settings with the effect off.
*
Set the polarity switch of the connected the FS-5U as shown
in the figure below.
POLARITY switch
