Boss Solar PROSOLAR, Руководство по установке

Страница: 11 / 14

Boss Solar Strip Thermal Solar Pool Heating | INSTALLATION MANUAL
10
Revision: C
Revision Date: 18/11/2021
Simultaneous / Integrated / Retro Fit Configuration
This system involves diverting the flow of water after the filtration system. This system is usually adopted when
independent solar suction and return lines do not exist, as it is an easy way to retro fit a solar system without
affecting any other part of the pools structure.
Requires:
•
1 x AS2_2S Digital Solar Controller or similar
•
1 x Check Valve (also known as a Non-Return or One-Way Valve)
•
2 x PVC Tees
•
1 x Booster Pump (that can deliver 3 litres per minute per m² of collector)
To Install
Identify and confirm the Pool Return line that is running from the Pool Filter This can be determined by identifying
the return line on a filters multi-port valve when using a media filter or when using a cartridge filter identifying the
return port.
Switch the system off and isolate any valve/s (if possible) to minimise water loss. Identify the best position to cut
into the line to install the two PVC Tees, Check Valve and Pump. Plumb as per the diagram above. Ensure all
pipework is dry and clean before attempting to glue.