Boss Solar PROSOLAR, Руководство по установке

Страница: 10 / 14

Boss Solar Strip Thermal Solar Pool Heating | INSTALLATION MANUAL
9
Revision: C
Revision Date: 18/11/2021
PLUMB THE SYSTEM TO THE PUMP HOUSE
Independent / Separate Suction System
The pool water is pumped directly from the pool to the solar collector and then back. This configuration requires
solar provisions to have been pre-installed. It is simple to install and does not interrupt the filtration system. This
type of plumbing allows the Solar System to operate independent of the filtration system.
Requires:
•
1 x AS2, AS2_2S Digital Solar Controller or similar
•
1 x Check Valve (also known as a Non-Return or One-Way Valve)
•
1 x Solar Pump (that can deliver 3-4 litres per minute per m² of collector)
To Install
Identify and confirm the solar Supply and Return lines, even if they are labelled. This can be achieved by
removing the caps (if there are any) and yelling down the pipes or by pouring water down the line. The Suction
line should join at the swimming pool to two suction points, typically deep on the wall of the pool. The Return line
is typically a single return outlet, usually higher on the pool wall than the suction lines. Plumb as per the diagram
above. Ensure all pipework is dry and clean before attempting to glue.