Boss Snowplow Snowrator SNR24001, Руководство пользователя

Страница: 20 / 48

Changing the Clock Display
Setting
1. Hold the button for 3 seconds to change the
clock settings.
2. Press the button again to switch between the
12-hour and 24-hour displays.
3. Wait for the information display screen to
resume showing the clock before pressing the
button again.
Changing the Time
1. Hold the button for 3 seconds to change the
clock settings.
2. Wait for the current time to start blinking.
3. Press the button again to increase the time.
4. If you want to decrease the time, wait for the
arrow on the bottom of the screen to switch
directions, then press the button again to
decrease the time.
5. Wait for the information display screen to
resume showing the clock before pressing the
button again.
Resetting the Trip Hour Meter
1. Hold the button for 3 seconds to reset the trip
meter.
2. Wait for the information display screen to
resume showing the hour meter before pressing
the button again.
Changing the Battery Voltage Alert
Setting
1. Hold the button for 3 seconds to change the
battery voltage alert setting.
2. Press the button again to increase the value at
which the low voltage alert triggers.
3. If you want to lower the value, wait for the arrow
on the bottom of the screen to switch directions,
then press the button again to decrease the
value at which the low voltage alert triggers.
4. Wait for the information display screen to
resume showing the battery voltage screen
before pressing the button again.
Changing the Pulses Per
Revolution Setting
1. Hold the button for 3 seconds to change the
pulses per revolution settings.
2. Press the button again to switch between 0.5,
1, 2, or 4.
3. Wait for the information display screen to
resume showing the engine speed screen
before pressing the button again.
Resetting the Maximum RPM
Tracker
1. Hold the button for 3 seconds to reset the
maximum rpm screen.
2. Wait for the information display screen to
resume showing the engine speed screen
before pressing the button again.
Changing the Backlight Setting
1. On any screen, hold the button for 3 seconds
and wait until the settings screen times out.
2. Before switching back to the previously
displayed screen, bL will appear on the screen.
3. Press the button again to switch between On,
Off, and Auto.
4. Wait for the information display screen to resume
showing the previously displayed screen before
pressing the button again.
After Operation
After Operation Safety
General Safety
•
Always shut off the machine, remove the key, wait
for all moving parts to stop, and allow the machine
to cool before adjusting, servicing, cleaning, or
storing it.
•
Clean up oil or fuel spills.
•
Shut off the fuel and sprayer before storing or
transporting the machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Use full-width ramps for loading the machine into
a trailer or truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
•
Do not store material in the sprayer tank.
•
Rinse the sprayer tank with fresh water before
storing it.
•
When storing the machine for more than 30
days, refer to
Storage (page 41) for important
information.
20