System Settings (Settings for the Entire RC-300)
34
MIDI-Related Settings
Here you can make settings for using the RC-300 connected with an external MIDI device or with a second RC-300 unit.
Reference
For details on MIDI, refer to “Connecting an External MIDI Device or Another RC-300 Unit” (p. 38).
Parameter
Value
Explanation
Sys:MIDI Rx Ch
1
MIDI Receive Channel
1–16
This procedure sets the MIDI channel used for receiving MIDI messages.
Sys:MIDI Omni
ON
MIDI Omni Mode
OFF
Messages will be received only on the channel specified by the MIDI Receive Channel
setting.
ON
Messages are received via all MIDI channels, regardless of the MIDI Receive Channel
settings.
Sys:MIDI Tx Ch
Rx
MIDI Transmit Channel
1–16
This procedure sets the MIDI channel used for transmitting MIDI messages.
Rx
The MIDI transmit channel will be the same as the MIDI receive channel.
Sys:MIDI Sync
MEMORY
Synchronizing the Tempo of Two RC-300 Units (MIDI
Sync)
Two RC-300 units can be synchronized after connecting them together using a MIDI cable. For details, refer to
“Connecting Two RC-300 Units” (p. 39). The “MIDI Sync” setting allows two RC-300 units to play back in synchronization
at the same tempo.
RC-300 (Master unit)
RC-300 (Slave unit)
MIDI OUT connector
MIDI IN connector
Reference
For more detailed information about MIDI and synchronization, refer to “MIDI settings” (p. 38).
MEMORY
The RC-300 will use the MIDI sync setting (p. 21) that’s specified by the phrase memory.
INTERNAL
This RC-300 unit will operate at its own specified phrase memory tempo. Choose the
“INTERNAL” setting if you’re using the RC-300 by itself, or if this is the master RC-300 unit.
MIDI
This RC-300 unit will synchronize to MIDI data received from the master RC-300 unit.
Choose the “MIDI” setting for the slave RC-300 unit.
Sys:MIDI PC Out
ON
MIDI Program Change Out
OFF
MIDI program change messages will not be transmitted.
ON
MIDI program change messages will be transmitted.