Boss Audio Systems B12ES, Руководство пользователя

Страница: 10 / 13

- 9 -
Remote Subwoofer Control Connection
Use the supplied remote subwoofer control to independently adjust the volume level output of the subwoofer.
Remote subwoofer control
• Using the supplied remote subwoofer control cable, connect the remote subwoofer control to the REMOTE
CONTROL on the subwoofer.
• We recommend to position the remote subwoofer control under the dash or in a similar location where using
it will not distract the driver. Fasten the remote subwoofer control using two supplied screws.
Troubleshooting
If you have problems using this product, check the following points before you request service. If you still have
a problem, contact our technical support.
Problem Solution
No power/Green LED not
lighting up
Check that the subwoofer is properly grounded (e.g. a clean contact point
on the vehicle chassis and the secure ground connection).
Check all fuses. Replace faulty one with the same type and rating.
Check that there is sufficient battery power on the terminal.
Check that there is sufficient voltage on the REM terminal when low-level
input connection is made.
If the red LED illuminates, this indicates that the subwoofer in protection
mode. Power off the subwoofer briefly, then power it on again.
Protection/Red LED lighting
up
Turn down volume on your source unit to prevent overdriving.
Reset the subwoofer by turning it off and on again (see the section
“Protection Mode” on page 6 for more details). If the red LED still lights up,
the subwoofer is faulty and needs servicing.