- 37 -
Bose Pow Configuration Utility User Guide
Appendix C: ControlCenter Analog Zone Controller DIP
Switch Configuration
When connecting to a Pow amplifier, use the following DIP switch settings to configure Con-
trolCenter analog zone controllers.
Up to four controllers can be connected directly to an amplifier's ControlCenter RJ-45 connector by
daisy-chaining controllers, or by using the Bose ControlCenter CV41 4-to-1 Converter.
The CC-1 DIP switches assign an ID that must match the ID of the controller that is assigned to the listen-
ing area in the UI. Each CC-1 controller requires DIP switch 3 to be
ON
. Only one of the DIP switches 5, 6, 7,
or 8 must be
ON
to match the ID assigned to the listening area in the UI. Set DIP switch 5 to
ON
for ID 1,
DIP switch 6 to
ON
for ID 2, DIP switch 7 to
ON
for ID 3, or DIP switch 8 to
ON
for ID 4.
CC-1 Controllers
One CC-1 controller:
This single CC-1 is configured as
ID 1
.
Two CC-1 controllers:
CC-1 #1 is configured as
ID 1
and CC-1 #2 is configured as
ID 2
.
Three CC-1 controllers:
CC-1 #1 is configured as
ID 1
, CC-1 #2 is configured as
ID 2
, and CC-1 #3 is configured as
ID 3
.
Four CC-1 controllers:
CC-1 #1 is configured as
ID 1
, CC-1 #2 is configured as
ID 2
, CC-1 #3 is configured as
ID 3
, and CC-1 #4 is
configured as
ID 4
.
