en
operation
32
Requirement:
The laundry is pre-
pared.
→
1.
Open the door.
Make sure that the drum is empty.
2.
Place the laundry in the drum.
3.
Close the door.
Ensure that there is no laundry
trapped in the door.
13.5 Adding detergent and
care product
Note:
Observe the information about
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.6 Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
1.
Press
开始
/
添衣
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended,
the display shows: "End".
2.
If is selected, the laundry is not
spun and the water is drained after
rinsing.
Notes
¡
If the laundry is not removed, the
Anti-Crease programme starts after
15 minutes. The programme takes
around 30 minutes. The display
shows 0
：
00
，
，
and "End"
alternately and appears.
Press any button to stop the Anti-
Crease programme and to remove
the laundry.
¡
If
Hot
appears, the appliance cools
the laundry.
When
Hot
goes out, the laundry
has cooled down.
13.7 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
开
始
/
添衣
.
3.
To resume the programme, after
the desired soaking time, press
开始
/
添衣
.
13.8 Adding laundry
1.
Press
开始
/
添衣
.
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note:
If appears, it is not pos-
sible to add laundry.
When goes out, it is possible to
add laundry.
2.
Open the appliance door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
开始
/
添衣
.
