Troubleshooting
en
43
Fault
Cause and troubleshooting
"E:36 / -10"
▶
Ensure that the pump cap is screwed in all the way
into the appliance. The handle on the pump cap
must be in a vertical position.
→
"Cleaning the drain pump", Page 39
"H:32"
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
▶
Clean the filters in the water inflow.
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
Water level measurement system is defective.
▶
Call the after-sales service.
→
The detergent drawer has not been pushed in as far
as it can go.
▶
Push the detergent drawer in as far as it will go.
The pump unit is not inserted.
1.
Insert the pump unit into the detergent drawer.
→
"Cleaning the detergent drawer", Page 36
2.
Push the detergent drawer in as far as it will go.
lights up.
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
"Cancelling the programme", Page 33
Water level is too high.
▶
Select a suitable programme for draining.
→
flashes.
Door is not closed.
1.
Close the door.
2.
Press
开始
/
添衣
to start the programme.
Laundry is caught in the door.
