en
Installation and connection
16
Water supply
Notes
■
Do not kink, crush, alter or cut
through the water supply hose
(otherwise, its strength can no longer
be guaranteed).
■
Only tighten the screw connections
by hand. If the screw connections
are tightened too tightly using a tool
(pliers), the threads may be
damaged.
Optimum water pressure in the mains:
100–1000 kPa (1–10 bar)
■
When the tap is turned on, the water
flow is at least 8 l/min.
■
If the water pressure is higher, install
a pressure reducing valve.
1.
Connect the water supply hose to
the tap (¾" = 26.4 mm) and to the
appliance (except models with
Aquastop):
– Standard
– Aqua-Secure
– Aqua-Stop
2.
Carefully turn on the tap and check
that the connection points are not
leaking.
Note:
The screw connection is under
water pipe pressure.
Water drainage
Notes
■
Do not kink or overextend the water
drainage hose.
■
Height difference between the
placement area and drainage point:
Minimum 60 cm –
maximum 100 cm
Drainage into a wash basin
:
Warning
Risk of scalding!
When washing at high temperatures,
there is a risk of scalding if you come
into contact with hot detergent solution
(e.g. when draining hot detergent
solution into a washbasin).
Do not reach into the hot detergent
solution.
Caution!
Water damage
When water is being pumped away, the
outlet hose is under water pressure and
may slip out of the wash basin or
connection point.
Secure the outlet hose so that it cannot
slip out.