Installation and connection
en
13
Note:
A hose clip Ø 24–40 mm (specialist
store) is also required for connection
to a siphon.
Connecting the water
Useful tools:
■
Spirit level for alignment
■
Size 13 socket wrench:
for loosening the transportation
and size 17: for aligning the
Installation
Note:
Humidity in the drum is caused
by the final inspection.
Secure installation
:
Warning
Risk of injury!
■
The washer dryer is heavy. Take
care when lifting it.
■
When lifting the washer dryer by its
projecting parts (e.g. washer dryer
door), the parts may break off and
cause injuries.
Do not lift the washer dryer by its
projecting parts.
■
If the hoses and power cables are
installed incorrectly, there is a risk of
stumbling and injury.
Lay hoses and cables in such a way
that there is no risk of stumbling.
Caution!
Damage to the appliance
■
Frozen hoses may tear or burst.
Do not install the washer dryer
outdoors and/or in an area where
there is a risk of frost.
■
When lifting the washer dryer by its
projecting parts (e.g. washer dryer
door), the parts may break off and
cause injuries.
Do not lift the washer dryer by its
projecting parts.
Installation area
Note:
Stability is important to prevent
the washer dryer from wandering!
■
The installation area must be firm
and level.
■
Soft floors and floor coverings are
not suitable.
■
To ensure good drying results,
ensure that the room is well
ventilated.
Installing the appliance on
a base or on a wooden joist
ceiling
Caution!
Damage to the appliance
The washer dryer may wander during
the spin cycle and topple or fall off its
base.
Always secure the washer dryer feet
with holding brackets.
Holding brackets: order no. WMZ 2200,
WX 975600, CZ 110600, Z 7080X0.
Note:
If installing on a wooden joist
ceiling:
■
If possible, install the washer dryer in
a corner.
■
Screw water-resistant wooden board
(min. 30 mm thick) to the floor.
@
Water drain hose
H
Elbow for securing the water
drain hose*
P
Water supply hose on standard/
Aqua-Secure models
*
depending on the model
