en
Faults and what to do about them
32
Information on the display
panel
Display
Cause/Remedy
A:01
Close the door immediately because of the rising water level. If an interruption
occurs,
A:01
and
OPEN
are displayed alternately.
A:02
The door is locked for safety reasons (water level and/or temperature too high).
■
Washing programme:
In pause mode
A:02
and
PAUS
are displayed alter-
nately. If you have to open the door, wait until the temperature has dropped
slightly or pump out the water (select e.g.
Spin
0
or
Drain
[
).
■
Drying programme:
If you have to open the door, wait until the temperature
has dropped slightly or set the drying programme to 15 min to cool down the
laundry.
If
A:02
is frequently displayed at the end of the drying programme:
■
Clean the air filter.
■
Run the
Fluff Clean
Ž
(cold) programme without laundry.
A:03
Door cannot be locked/unlocked due to high temperature. Leave the washer
dryer switched on for about 1 min. The washer dryer can then be locked/
unlocked again.
hot
The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the display disappears, after which the
door can be opened.
¹
■
Flashes
(no water supply): Tap turned on? Water inlet filter blocked? Clean
Water hose kinked or blocked?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E:18
Drain pump blocked; clean the drain pump. Clean the drainage hose
on the siphon.
ªªª
■
Hold down button
Secar
(Drying)
for 3 seconds to delete the display.
■
Clean the air filter.
■
Run the
Fluff Clean
Ž
(cold) programme without laundry.
LO kg
,
HI kg
Laundry amount information. On when drying phase finished.
LO kg
: Signals a small load for drying,
HI kg
: Signals a very high load for drying.
Other displays
Turn the programme selector to
Ú
Stop
. The appliance is switched off. Wait 5 s
and switch on again. If the display is indicated again, call customer service.
