en
Operating the appliance
14
1
Operating the
appliance
Ope
rat
ing
the
app
li
anc
e
Preparing the washer dryer
The washer dryer was tested before
delivery. To remove residual water from
the test procedure, the first wash cycle
should be run without laundry using the
Fluff clean
l
programme.
Before washing/drying for the first time
Note:
■
Never switch on a damaged washer
dryer!
■
Inform your customer service!
1.
Insert mains plug.
2.
Turn the tap on.
The end of the drying programme is
followed by an automatic fluff
cleaning cycle. The tap must be
turned on even when selecting a
drying programme.
Note:
■
Always provide good ventilation in
the room where the washer dryer is
located so that air produced during
the drying phase can be evacuated.
■
Always keep the inlets and outlets
for the cooling air clear.
3.
Open the door.
Selecting the programme/
Switching on the appliance
Note:
If you have activated the childproof lock,
you must deactivate it before you can
set a programme.
Select the required programme with the
programme selector. Can be rotated in
either direction.
The washer dryer is switched on.
The following figures are indicated
continuously on the display panel for
the selected programme:
■
the programme duration (when door
is closed),
■
the preset temperature,
■
the preset spin speed and
■
the maximum load (when door is
opened),
■
...
