en
Positioning and connecting
38
Caution!
Water damage
The connection points for the water
supply hose and water drain hose are
under high water pressure. To prevent
leaks and water damage, you must
follow the instructions in this section.
Notes
■
In addition to the safety information
listed here, the local water and
electricity supplier may have special
requirements.
■
If in doubt, have the appliance
connected by a specialist.
Installation surface
Note:
The washer dryer must be stable
so that it does not move around.
■
The installation surface must be firm
and level.
■
Soft floors/floor coverings are not
suitable.
Installing the appliance on
a base or on a wooden joist
ceiling
Caution!
Damage to the appliance
The washer dryer may wander during
the spin cycle and topple or fall off its
base.
Always secure the washer dryer feet
with holding brackets.
Holding brackets: order no.
WMZ 2200, WX 975600, CZ 110600,
Z 7080X0.
Note:
If installing on a wooden joist
ceiling:
■
If possible, install the washer dryer in
a corner.
■
Screw water-resistant wooden board
(min. 30 mm thick) to the floor.
Installing the appliance in a
kitchenette
:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
Do not remove the appliance covering
plate.
Notes
■
Recess width of 60 cm required.
■
Only install the washer dryer
underneath a continuous worktop
that is securely connected to
adjacent cabinets.
Removing the transport locks
Caution!
Damage to the appliance
■
The machine is secured for
transportation using transport locks.
If the transport locks are not
removed, the drum, for example,
may become damaged when the
machine is operated.
Before using the appliance for the
first time, make sure that you
completely remove all four transport
locks. Keep the locks in a safe
place.
■
To prevent transport damage from
occurring if the appliance is moved
at a later date, you must refit the
transport locks before transporting
the appliance.
