en
Operating the appliance
18
■
If an individual drying programme is
selected, please do not add
detergent and/or care product in the
appliance.
Measuring aid* for liquid detergent
*depending on the model
Position the measuring aid for
measuring the correct amount of liquid
detergent:
1.
Pull out the detergent drawer. Press
down the insert and fully remove the
drawer.
2.
Slide the measuring aid forwards,
fold it down and click it into place.
3.
Reinsert the drawer.
Note:
Do not use the measuring aid for
gel detergents and washing powder, or
for programmes with prewash or when
"Finish in" time is selected.
For models without a measuring aid,
pour the liquid detergent into the
appropriate dispenser and place it in
the drum.
Starting the programme
Touch the
Start/Reload
A
button. The
indicator lamp is lit and the programme
starts.
Note:
If you want to secure the
programme to prevent it from being
adjusted inadvertently, select the
childproof lock.
The display panel shows the Ready in
time while the programme is running or
the programme duration and the
programme progress symbols when the
washing programme has started.
Display panel
Childproof lock
You can secure the washer dryer to
prevent the set functions from being
changed inadvertently. To do this,
activate the childproof lock when the
programme has started.
Activating/deactivating: Touch and hold
the buttons
0
rpm
and
ñ
Ready in
for
approx. 3 seconds. The symbol
E
is
indicated in the display. If the button
signal is activated, an acoustic signal
sounds.
■
E
lights up: The childproof lock is
activated.
■
E
flashes: The childproof lock is
active and the programme selector
has been adjusted. To prevent the
E
symbol from flashing, reset the
programme selector to the initial
programme. The symbol lights up
again.
Note:
The childproof lock may remain
activated until the next programme
starts, even after the washer dryer has
been switched off. If this is the case,
deactivate the childproof lock before the
programme starts and, if required, re-
activate after the programme starts.
Adding the laundry
When the programme has started, the
laundry can be reloaded or taken out as
required.
Touch the
Start/Reload
A
button. The
washer dryer checks whether reloading
is possible.
