Bosch WVG30440TR, Инструкция по эксплуатации и руководство по установке

Страница: 30 / 48

en
Operating the appliance
30
Reloading the laundry
When the programme has started, the
laundry can be reloaded or taken out as
required.
Touch the
Ba ş lat/Beklet (Start/Reload)
button. The washer dryer checks
whether reloading is possible.
Notes
■
If there is a high water level, high
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
Õ
is lit
~
Reloading is not possible.
To continue the programme, select
the
Ba ş lat/Beklet (Start/Reload)
button.
■
Do not open the door until the door
lock symbol
Õ
goes out.
■
Do not leave door open for
a prolonged period – water could
run out of the laundry.
■
The reloading function cannot be
activated during the drying phase.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Select
Ba ş lat/Beklet (Start/Reload)
.
2.
Select another programme. If
required, adjust the default settings
and/or select additional functions.
3.
Select
Ba ş lat/Beklet (Start/Reload)
.
The new programme starts from
the beginning.
Interrupting or ending the
programme
For washing programmes at high
temperature:
1.
Touch
Ba ş lat/Beklet (Start/Reload)
button.
2.
To cool down laundry: select
O
Durulama (Rinse)
.
3.
Touch
Ba ş lat/Beklet (Start/Reload)
button.
For washing programmes at low
temperature:
1.
Touch
Ba ş lat/Beklet (Start/Reload)
button.
2.
Select
S ı kma/Bo ş altma (Spin/Drain)
0
/
[
.
3.
Touch
Ba ş lat/Beklet (Start/Reload)
button.
For drying programmes:
1.
Select
Kurutma (Intensive Dry)
5
or
Hassas kurutma (Gentle Dry)
‰
.
2.
Touch
Š
Kurutma (Dry)
button, and
set drying time to 20 minutes.
3.
Touch
Ba ş lat/Beklet (Start/Reload)
button.
End of the programme
End
or
– – – –
(
Rinse stop
= without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal
If
– – – –
(
Rinse stop
= without final
drain/spin cycle) was selected, press
Ba ş lat/Beklet (Start/Reload)
button to
start the final drain/spin cycle.