en
Crease-removal function
40
4.
¤
will appear on the display.
Note:
If
¤
does not appear on the
display, the water tank is already
filled with the correct amount of
water and the program will start.
5.
Pull out the condensation container
horizontally.
6.
Use the water jug provided to pour
approx. 180 ml cold drinking water
into the filling hole in the
front
of the
appliance, until
¤
goes out on the
display and an audible signal
sounds.
Note:
If you pour more than 180 ml
drinking water into the appliance and
¤
does not go out on the display,
this means that the drinking water
has been poured into the wrong
filling hole or the appliance is not
fully level. Pour the drinking water
into the filling hole on the front or
make the appliance level.
7.
Push the condensation container
back into the appliance until you feel
it lock into place.
8.
Press
A
(Start/Pause).
Programs for removing
creases
■
Do not run crease-removal programs
without a load in the drum. Comply
with the washing instructions on the
clothing label and do not exceed the
maximum permitted load for the
crease-removal
■
Opening the door during a crease-
removal program pauses the
program. To resume the program,
close the door and press
A
(Start/
Pause).
■
Crease-removal programs run for
approx. 45 minutes on average.
They may run for longer at low
ambient temperatures; at high
ambient temperatures, the run time
may be reduced.
■
There may be some extra noise
when a crease-removal program is
running.
■
Crease removal results may vary
depending on the type of fabric, the
amount of laundry and the selected
program. For best results, take the
laundry out of the machine as soon
as the program comes to an end,
hang it on a clothes hanger to finish
drying and reshape it while still
damp.
Содержание WTX8HKP9SN
Страница 63: ...6 ...