en
Home Connect
40
Activate
as follows:
1.
Select the programme you require.
2.
Use the
N
and
M
selection buttons
for the "Finished in" time to set the
required time.
3.
Press
Start/
A
Pause
.
4.
Press
}
Remote Start
.
£
appears in the display.
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
If the time changes on the display to
„
.
‹œ
, for example, the smart energy
system (Energy manager) has
established a time at which your
appliance can start. The programme will
end after the specified time.
Notes
■
If the smart energy system (energy
manager) does not start your
appliance, the programme will still
be started before the set time period
ends.
The programme ends when the time
period ends.
■
For safety reasons,
}
Remote Start
and, in turn, are deactivated in the
following circumstances:
– Press Start/
A
Pause.
– Open the door.
– Press
#
to switch off the
appliance.
– Power failure.
If the function is deactivated, the
M
Finished in
ñ
N
remains active.
Adding more laundry or removing
laundry:
Note:
If the function has already been
activated but the programme has not
yet started, you will still be able to load
more laundry or remove some from the
drum.
1.
Press
Start/
A
Pause
.
2.
Open the door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
Start/
A
Pause
.
6.
Press
}
Remote Start
.
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
Intelligent program
recommendation
After you have washed your laundry in
the washing machine, the dryer will
recommend a suitable program for
drying your laundry.
The expected duration of the
recommended program is determined
based on the washing program you just
used.
To determine the best drying program
to use, your appliances must transmit
and receive information.
