Signal setting
en
29
M
Signal setting
Signal setting
You can change the following settings:
■
The spin speed that is used for
spinning your laundry before it is
dried,
■
The volume of the audible signal at
the end of the programme,
■
The volume of the audible button
signals,
■
The current rating for your dryer's
fuse (10 A or 13 A).
Note:
The values for the energy
label are determined using a circuit
breaker/fuse rating of 13 A. If the
circuit breaker/fuse rating is
changed to 10 A, the drying time
and energy consumption will be
higher. You can find details on this in
the consumption values table.
You will need to activate the setting
mode in order to change these settings.
Activating setting mode
1.
Switch the dryer on.
2.
Select the Cottons programme in
position 1 and wait 5 seconds.
Setting mode is now activated. The
symbols go out on the display panel
and the programme duration is
displayed.
1.
Press and hold the Start button and,
at the same time, turn the
programme selector clockwise to
position 2.
2.
The
spin speed
is shown on the
display.
3.
Press the "Ready in" time button or
the drying time button to change the
spin speed.
4.
Turn the programme selector
clockwise to position 3.
5.
The volume of the
audible signal at
the end of the programme
is shown
on the display.
1 = quiet, 2 = medium,
3 = loud, 4 = very loud
6.
Press the "Ready in" time button or
the drying time button to change the
volume.
Содержание WTN8543SME
Страница 39: ...6 ...
